TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 369
Hard disk drives / solid state drives
Ê Open the side / top cover as described in section "Removing the top cover"
on page 79 (rack server) or "Removing the side cover" on page 88 (tower
server).
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page 79.
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 389.
7.5.1.3 Installing SAS expander board spacer bolts
I This step is only necessary if SAS expander board spacer bolts are not
already mounted in the system. Otherwise, please proceed to section
"Installing the SAS expander board" on page 368.
Ê Remove the system board as described in section "Removing the system
board" on page 858.
Ê Remove the system board carrier as described in section "Removing the
system board carrier" on page 106.
Figure 230: Installing SAS expander board spacer bolts (A)
Ê Locate the four mounting bolts (see arrows).
To Next Page
Loading...
