EasyManua.ls Logo

Fujitsu PRIMERGY TX300 S7 - Removing the Anti-Tilt Bracket

Fujitsu PRIMERGY TX300 S7
962 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 129
Basic hardware procedures
4.10.2 Removing the anti-tilt bracket
Figure 64: Removing the anti-tilt bracket
Ê Loosen the two knurled thumb screws on the anti-tilt bracket (1).
Ê Remove the anti-tilt bracket from the rear of the server (2).

Table of Contents

Other manuals for Fujitsu PRIMERGY TX300 S7

Preview: Operating Manual
Operating Manual90 pages
Preview: System Configurator And Order-Information Guide
System Configurator And Order-Information Guide36 pages

Related product manuals