422 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Expansion cards and backup units
Figure 265: Securing the expansion card
Ê Secure InfiniBand cards with one M3 x 4.5 mm screw each.
I In case of all other standard expansion cards, fixation with the locking
bar is sufficient.
Ê Insert (1) and close the PCI slot bracket locking bar (2) until the latch locks
in place (see close-up).
Ê If applicable, install SFP+ transceiver modules into the new expansion card,
as described in section "Installing SFP+ transceiver modules" on page 575.
9.2.1.6 Connecting cables to the expansion card
Ê If applicable, connect internal cables to the expansion card.
I For a complete cabling overview, please refer to section "Cabling
overviews" on page 911.
To Next Page
Loading...
