TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 179
Power supply
6.3 Removing PSU modules
I Note for servers using CMA (Cable Management Arm)
Since the installed CMA is blocking PSU modules, additional steps are
required in order to remove or replace PSU modules:
Ê Unlock the CMA stopper.
Ê Remove the CMA stopper with the mounted crossbar.
Ê Support the CMA stopper, the crossbar and the CMA arm including
cables with your right hand.
Ê Remove the PSU module and install a PSU dummy module into the
empty bay.
Ê Remount the complete assembly (CMA stopper, crossbar and CMA
arm) into the rail.
6.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing the PSU module: tool-less
Customer Replaceable Units (CRU)
Average task duration: 5 minutes
To Next Page
Loading...
