820 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
System board and components
Ê When working on a rack-mounted server, extend it out of the rack as
described in section "Extending the server out of the rack" on page 76.
If further required, remove the server from the rack as described in section
"Removing the server from the rack" on page 77.
Ê Open the side / top cover as described in section "Removing the top cover"
on page 79 (rack server) or "Removing the side cover" on page 88 (tower
server).
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
14.2.1.3 Installing the UFM board
Figure 569: UFM kit
Pre-assembled UFM flash module kit (S26361-F3514-V3):
1 2 GB UFM SLC
A3C40104433
2 UFM spacer
A3C40109081
3 UFM nylon screw
A3C40109082
To Next Page
Loading...
