736 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Accessible drives
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 389.
I Removing the front cover is not required in order to replace the slimline
ODD or LSP in the 2x 3.5-inch HDD extension box.
12.6.3.3 Removing the 2x 3.5-inch HDD extension box
Ê Remove all cables from the 2x 3.5-inch HDD extension box backplane.
Ê Remove all cables from the slimline ODD.
Ê Remove the LSD cable from system board connector SMB 1.
Ê Remove the 2x 3.5-inch HDD extension box from the server as described in
section "Removing the 2x 3.5-inch HDD extension box" on page 322.
12.6.3.4 Removing the slimline ODD from the HDD extension box
Ê Remove the defective slimline ODD from the 2x 3.5-inch HDD extension box
as described in section "Removing the slimline ODD from the extension box"
on page 728.
12.6.3.5 Removing the LSD module from the HDD extension box
Ê Remove the defective LSD module from the 2x 3.5-inch HDD extension box
as described in section "Removing the LSD module from the extension box"
on page 731.
12.6.3.6 Installing the slimline ODD into the HDD extension box
Ê Install the new the slimline ODD into the 2x 3.5-inch HDD extension box as
described in section "Installing the slimline ODD into the extension box" on
page 716.
12.6.3.7 Installing the LSD module into the HDD extension box
Ê Install the new LSD module into the 2x 3.5-inch HDD extension box as
described in section "Installing the LSD module into the HDD extension box"
on page 721.