Fujitsu PRIMERGY TX300 S7 - Installing the Multibay Box

694 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Accessible drives
12.5.1.6 Installing the Multibay box
Figure 483: Checking mounting bracket positions
Ê Ensure that the four mounting brackets in the desired accessible drive bay
have not been bent out. If necessary, proceed as follows:
Ê Using a screw driver, bend the mounting brackets of the upper
installation bay inwards, so that their sides are flush with the bay walls
(see close-up).
Ê Bend down the upper two mounting brackets (see blue circles).
Ê Bend up the lower two mounting brackets (see orange circles).