808 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Front panel and external connectors
Ê Pull the front VGA cable out through the mounting bracket on the front panel
frame and remove it (2).
13.3.2.5 Reassembling the front panel module
Ê Mount the front panel module cover on the front panel frame as described in
section "Mounting the front panel module cover" on page 769.
13.3.2.6 Reinstalling the front panel module
Ê Reinstall the front panel module as described in section "Installing the front
panel module" on page 771.
13.3.2.7 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 130.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section "Connecting the server to
the mains" on page 133.
Ê If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section "Enabling
BitLocker functionality" on page 165.
To Next Page
Loading...
