330 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Hard disk drives / solid state drives
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Reinstall all hard disk drives into their original slots in the HDD extension box
as described in section "Installing 3.5-inch HDD modules" on page 272.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
Ê When working on a rack-mounted server, secure it in the rack as described
in section "Sliding the server into the rack" on page 132.
If the server has been completely removed from the rack for maintenance
purposes, reinstall and secure it in the rack as described in section
"Mounting the server in the rack" on page 130.
Ê Reconnect the AC power cords to the power supply units and secure them
with PSU cable brackets as described in section "Connecting the server to
the mains" on page 133.
7.4.5 Installing the 4x 3.5-inch HDD extension box
7.4.5.1 Required tools
● Preliminary and concluding steps: tool-less
● Installing the HDD extension box:
– Slotted screw driver (for bending in or out accessible drive mounting
brackets)
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
To Next Page
Loading...
