Fujitsu PRIMERGY TX300 S7 - Switching on the ID Indicator; Completing the Maintenance Task; Updating or Recovering the System Board BIOS and Irmc

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 147
Basic software procedures
5.1.6 Switching on the ID indicator
When working in a datacenter environment, switch on the ID indicator on the
front and rear connector panels of the server for easy identification.
I For further information, refer to section "Locating the defective server" on
page 64 or to the "ServerView Suite Local Service Concept (LSC)"
manual.
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch on the system identification
LEDs.
I For further information, refer to section "Front panel controls and
indicators" on page 958.
Using ServerView Operations Manager
Ê In ServerView Operations Manager Single System View and press the Locate
button in the title bar to switch on the ID indicators.
5.2 Completing the maintenance task
5.2.1 Updating or recovering the system board BIOS and
iRMC
After replacing the system board, it is essential to upgrade the BIOS and iRMC
to the latest version. The latest BIOS and iRMC versions are available from the
Fujitsu support internet pages at:
http://ts.fujitsu.com/support/ (EMEA market)
http://jp.fujitsu.com/platform/server/primergy/downloads/ (Japanese market)
I Fujitsu does not assume responsibility for any damage done to the
server or for the loss of any data resulting from BIOS updates.