674 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Accessible drives
Figure 467: Routing cables
Ê Run the SAS and power cables through the cable clamps (see arrows) as
shown.
12.2.6 Concluding steps
Perform the following procedures to complete the task:
Ê Reinstall the system fan holder as described in section "Installing the system
fan holder" on page 390.
Ê Reinstall the air duct as described in section "Installing the system air duct"
on page 102.
Ê Close the front cover and reinstall the ID card as described in section
"Closing the server" on page 112.
Ê Close the side / top cover as described in section "Mounting the top cover"
on page 115 (rack server) or "Mounting the side cover" on page 122 (tower
server).
To Next Page
Loading...
