TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 791
Front panel and external connectors
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 389.
13.2.2.3 Removing and preparing the front panel module
Ê Disconnect the front panel cables from the system board as described in
section "Removing front panel cables from the system board" on page 762.
Ê Remove the front panel module from the chassis as described in section
"Removing the front panel module" on page 765.
Ê Remove the front panel module cover from the front panel frame as
described in section "Removing the front panel module cover" on page 768.
13.2.2.4 Removing the front LAN connector
Figure 557: Removing the front panel connector
Ê Carefully unlatch the front LAN cable connector from the mounting bracket
(1).
Ê Pull the front LAN cable out through the mounting bracket on the front panel
frame and remove it (2).
To Next Page
Loading...
