158 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Basic software procedures
Executing the fan test via the iRMC Web interface
Ê Log into the iRMC web interface.
Ê Under Sensors select Fans.
Ê Select the replaced fan in the system fans group and click Start Fan Test.
I For more detailed information on iRMC settings, refer to the
"iRMC S2/S3 - integrated Remote Management Controller" user guide.
Executing the fan test via ServerView Operations Manager
Ê Open the ServerView Operations Manager and log in.
Ê Under Administration select Server Configuration.
Ê Click the Configuration tab and select Other Settings.
Ê Under Daily Fan Test, set the daily fan test time to a few minutes from the
current time.
Ê Click Save Page.
The fan test will be started at the specified time.
Ê After the fan test is complete, restore the time setting to its initial value and
click Save Page.
I For more detailed information, refer to the "ServerView Operations
Manager" user guide.
For the Japanese market: Executing the fan test via Chassis ID Prom Tool
Ê Prepare a boot medium (CD) containing the Chassis ID Prom Tool.
Ê Insert the CD into the DVD drive and close the drive tray.
Ê Shut down and restart the server.
The server will boot from the Chassis ID Prom Tool medium.
Ê After the boot process is complete, press [ESC] to enter the command
prompt screen.
Ê Enter IPMIVIEW.EXE and press [Enter] to start the IPMI Tool.
Ê Under System Specific Functions select Fan Test and press the [F9] function
key to start the fan test.
To Next Page
Loading...
