TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 221
Hard disk drives / solid state drives
Ê Pinch the green locking clips (1) and fully open the locking lever (2).
I Thereby, the HDD / SSD module is pushed out of its drive bay by
about 1 cm and disconnected from the SAS / SATA backplane.
Ê Wait about 30 seconds to allow the hard disk drive to spin down.
I This is not necessary when removing a solid state drive.
Figure 107: Removing a 2.5-inch HDD / SSD module
Ê Pull the HDD / SSD module completely out of its bay.
To Next Page
Loading...
