442 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Expansion cards and backup units
Connecting the NCSI sideband cable to the system board
I Connecting the NCSI sideband cable is only necessary in order to use
the Modular LAN controller as a shared LAN interface, that allows both,
management and dedicated LAN connections.
If the Modular LAN controller is to be used for dedicated network
connections only, please skip this section.
Figure 279: Connecting the NCSI sideband cable to the system board
Ê Connect the loose end of the NCSI sideband cable to the system board:
Connector Cable
NC-SI NCSI sideband cable T26139-Y4015-V101
To Next Page
Loading...
