Fujitsu PRIMERGY TX300 S7 - Page 473

TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 473
Expansion cards and backup units
– The number of ECC Errors (4) has not greatly increased (beyond 100)
during a number of hours.
I In order to reset the ECC error counter, enter the following
command: nvidia-smi [-p/-v] -g <GPUID>
Ê If one or more of the above conditions is not fulfilled, although sufficient
power supply has been assured as described in section "Checking GPGPU
operation" on page 474, replace the GPGPU card.
'%%'TTQTU
8QNCVKNG
5KPING$KV
&GXKEG/GOQT[
4GIKUVGT(KNG
.%CEJG
.%CEJG
6QVCN
&QWDNG$KV
&GXKEG/GOQT[
4GIKUVGT(KNG
.%CEJG
.%CEJG
6QVCN
#IITGICVG
5KPING$KV
&GXKEG/GOQT[
4GIKUVGT(KNG
.%CEJG
.%CEJG
6QVCN
&QWDNG$KV
&GXKEG/GOQT[
4GIKUVGT(KNG
.%CEJG
.%CEJG
6QVCN