TX300 S7 / RX350 S7 Upgrade and Maintenance Manual 739
Accessible drives
Ê Pull out the ID card and open the front cover as described in section
"Opening the server" on page 79.
I The front cover only needs to be removed in order to remove
accessible drive dummy covers (see section "Removing accessible
drive dummy covers" on page 656). If the HDD extension box is
already installed in the server and will be removed in order to install
a slimline ODD or LSD module, skip this step.
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
Ê Remove the system fan holder as described in section "Removing the
system fan holder" on page 389.
Ê If the HDD extension box is already installed in the server, disconnect all
cables from the HDD backplane and remove the extension box as described
in section "Removing the 4x 3.5-inch HDD extension box" on page 341.
To Next Page
Loading...
