EasyManua.ls Logo

Fujitsu PRIMERGY TX300 S7 - Page 952

Fujitsu PRIMERGY TX300 S7
962 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
952 Upgrade and Maintenance Manual TX300 S7 / RX350 S7
Appendix
Ê Remove the air duct as described in section "Removing the system air duct"
on page 100.
Ê Press the Indicate CSS button (1) to highlight defective components.
Component LEDs
I LEDs A, B and C are visible from the outside on the server rear. All other
LEDs are only visible if the server cover has been opened.
Indicator Status Description
A ID indicator blue on
server has been highlighted using
ServerView Operations Manager or the
ID button on the front panel for easy
identification
B
CSS
(Customer Self
Service)
off no critical event (CSS component)
yellow on prefailure detected (CSS component)
yellow
flashing
CSS component failure
C
GEL
(Global Error
LED)
off no critical event (non CSS component)
orange on
prefailure detected (non CSS
component)
orange
flashing
non CSS component failure
Possible reasons:
sensors report overheating
sensor is defective
–CPU error
software reports an error
D PCI card
off PCI card operational
orange on PCI card failure
E CPUs
off CPUs operational
orange on CPU failure
F Memory
off memory module operational
orange on memory module failure
G
PSUs
green on PSUs operational
H orange on PSU failure

Table of Contents

Other manuals for Fujitsu PRIMERGY TX300 S7

Related product manuals