5. ROUTES
5-16
5.11.4 How to skip a point on a route
You can skip a route point to go to the succeeding route point in the route. Open the
Slide-out menu, the tap [Route] and [Skip Next]. The current route point is skipped
then the next route point becomes the destination. The skipped route point is greyed
out.
5.11.5 Waypoint switching mode
When you arrive to a route point, your unit automatically changes to the next route
point according to the waypoint switching mode selected on the menu.
[Cross Line]: Change the waypoint when the ship moves through an imaginary cross
line (vertical line) that passes through the center of the destination point.
[Circle]: [Circle]: Change the waypoint when the ship comes within the circle.
[Circle and Cross Line]: Change the waypoint when one of the above two conditions
is met.
1. Go to the Home screen, then tap [Settings]→[Routes]→[WPT Switch Mode].
2. Tap [Circle and Cross Line], [Circle] or [Cross Line]. For [Circle and Cross Line] or
[Circle], go to step 3. For [Cross Line], go to step 6.
3. Tap [<] on the title bar to go back one layer in the menu.
4. Tap [Switching Circle Radius] to show the software keyboard.
5. Enter the radius for the circle, then tap [9]
6. Tap the close button on the title bar to finish.
5.11.6 How to automatically zoom a route
You can get automatic range change after you have moved past the Goto point. Use
this feature to find the next Goto point in the route when the next Goto point is not with-
in the current display range.
1. Go to the Home screen, then tap [Settings]→[Routes].
2. Turn [Route Auto Zoom] on or off.
3. Tap the close button on the title bar to finish.
Cross line
[Circle and Cross Line]
[Circle]
[Cross Line]
Arrival area
The value for the circle
radius is set in [Switching
Circle Radius].
Cross line
To Next Page
Loading...
Need help?
General