4. POINTS, BOUNDARIES
4-19
4.15.3 How to go to a point selected from the Points list
1. Go to the Home screen, then tap [Lists]→[Points] to open the [Points] list.
2. If you need to sort the list, use one of the sort buttons at the top of the list.
3. Tap the point to use.
4. Tap [Goto].
The following occurs:
• The Goto point is highlighted in the [Points] list.
• A purple line and a yellow line appear on the point. The purple line is the course to
follow to get to the point. The yellow line is the shortest course from the current po-
sition to the Goto point.
• The navigation bar (provides destination information) appears at the top of the dis-
play.
For how to use the [Restart] and [STOP] buttons, see section 4.16.
• The waypoint switching method is determined according to the respective setting on
the menu. Select the format by [Settings]→[Routes]→[WPT Switch Mode]. Select
[Circle and Cross Line], [Circle] or [Cross Line].
• The XTE lines, red for port side, green for starboard side, appear. You can show or
hide these lines with [Cross Track Error Lines] in the [Settings]→[Routes] menu.
Note: If you want to be notified when you reach the Goto point (the end of a route),
turn on [End of Route Notification] in the [Routes] menu (see subsection 5.11.9). Then
the message "End of Route" appears when you reach the end of a route. For the ar-
rival timing, see subsection 5.11.5.
STOP (navigation)
button
Restart (navigation)
button
Distance to
waypoint
Bearing to
waypoint
Targeted time of
arrival*
Time to go to next
waypoint*
*
These figures are the same when navigating to a point.
To Next Page
Loading...
Need help?
General