8. MULTI BEAM SONAR DFF-3D
8-4
8.2 Multi-Sounder Display Operations
This section covers the functions available with the multi-sounder display. For the
menu items shared with the conventional fish finder, see chapter 7. To show the
[Multi-Sounder] menu, open the layers menu and then tap [Multi-Sounder Settings]; or
from the home screen, tap [Settings]→[Multi Beam Sonar]→[Multi-Sounder].
Layers menu for multi-sounder
8.2.1 How to switch between TX and STBY
Open the layers menu and then select [ON] for [TX/STBY] to start transmitting, [OFF]
to stop transmitting. "Stand-by" appears at the center of the screen when transmission
is stopped.
8.2.2 How to switch between single beam and triple beam presenta-
tions
1. Tap the multi-sounder display to show the pop-up menu.
2. Tap [Mode].
3. Select [Single Beam] or [Triple Beam].
8.2.3 How to set the TX beam angle
You can set the TX beam angle for the port, starboard and downward beams.
1. Tap the multi-sounder display to show the pop-up menu.
2. Tap [Beam Angle].
3. Select the beam angle.
8.2.4 How to set the TX beam width
You can set the TX beam width for the port, starboard and downward beams.
1. Tap the multi-sounder display to show the pop-up menu.
2. Tap [Beam Width].
3. Select the beam width.
To Next Page
Loading...
Need help?
General