8. MULTI BEAM SONAR DFF-3D
8-7
8.3.4 Availability of points and event marks registration, and go to a
point
For how to register points and event marks, see chapter 4.
The table below shows function availability according to latitude/longitude, heading
data presence or absence. If there is no latitude/longitude data, none of the functions
below are available.
Latitude/Longitude / Heading data: YES
Latitude/Longitude: YES, Heading data: NO
8.4 Cross Section Display Operations
This section covers the functions available with the cross section display. For the
menu items shared with the conventional fish finder, see chapter 7. To show the
[Cross Section] menu, open the layers menu and then tap [Cross Section Settings]; or
from the home screen, tap [Settings]→[Multi Beam Sonar]→[Cross Section]. The pro-
cedures in this manual, for sake of brevity, replace “open the [Cross Section] menu.”
Layers menu for cross section
8.4.1 How to switch between TX and STBY
Open the layers menu and then select [ON] for [TX/STBY] to start transmitting, [OFF]
to stop transmitting. "Stand-by" appears at the center of the screen when transmission
is stopped.
Item Starboard Port
Point registration Yes Yes
Go to point Yes Yes
Event mark registration Yes Yes
Item Starboard Port
Point registration No No
Go to point No No
Event mark registration Yes (registered at the center)
To Next Page
Loading...
Need help?
General