9. FILE OPERATIONS
9-3
4. Tap [OK]. The message "IMPORT SUCCEEDED" appears if the importing was
successful.
5. Tap the [OK] to erase the message.
6. Tap the close button on the title bar to finish.
9.4 How to Export, Import Track
How to export track
This unit saves up to 30,000 points of track data. You can export all tracks to a media
as follows.
1. Put the appropriate formatted media in the USB port.
2. Open the Home screen, then tap [Settings]→[Files]→[Export Tracks]. A list of files
stored on the SD card or USB flash memory appears.
3. Tap the destination for the track. You are asked if you are sure to proceed.
4. Tap [OK]. The message "EXPORT SUCCEEDED" appears if the exporting was
successful.
5. Tap [OK] to erase the message.
6. Tap the close button on the title bar to finish.
How to import tracks
You can import the tracks stored on a media to the internal memory of this unit.
Note: Imported track is transfered to each NavNet TZtouch3 unit. Track cannot be
shared among units in the network.
1. Put the appropriate media in the USB port.
2. From the Home screen, tap [Settings]→[Files]→[Import Tracks]. A list of tracks
stored in the media appears.
3. Tap the tracks file to import. You are asked if you are sure to import tracks.
4. Tap [OK]. The message "IMPORT SUCCEEDED" appears if the exporting was
successful.
5. Tap [OK] to erase the message.
6. Tap the close button on the title bar to finish.
USB 1
XXXX. XXX.tzx
XXXX. XXX.tzx
XXXX. XXX.tzx
XXXX. XXX.tzx
To Next Page
Loading...
Need help?
General