4. POINTS, BOUNDARIES
4-3
Method 3: Register point on the Points list
1. Go to the Home screen, then tap [Lists]→[Points] to show the [Points] list.
2. Tap the [Add Point] button at top of the screen. The [Point] screen shows the lat-
itude and longitude of the point to be registered and its location (on the preview
screen).
3. Edit the point referring to section 4.10.2.
4. Tap X on the title bar to close the menu.
Method 4: Input from external equipment
External equipment (fish finder, etc.) can output points to this equipment. TLL data
(NMEA 0183 format) from the external equipment is output to this equipment via an
NMEA data converter (IF-NMEA2K2, option). The latitude and longitude position of
the point is marked with the event icon.
4.2.2 How to enter an event mark
Method 1: EVENT/MOB key (TZT12F only)
Press the EVENT/MOB key. The event mark is automatically named as “WPXXX”
(XXX=3 digit number, sequential). You can turn off automatic naming (only the icon is
shown) of a point. See section 4.12.
Method 2: Creating Events window
At the top left corner, tap the event icon to show the [Creating Events] window. Tap
desired event mark.
Method 3: Two-finger tap
An event mark can be entered by tapping the screen with two fingers. To enable this
function, open [Settings]→[General]. Set [Two Finger Tap Function] (or [Two Finger
Long Tap Function] for [Event Mark] (see section 1.16). Then, tap (long tap if the func-
tion is set up for long tap) the screen with two fingers to show the [Creating Events]
window. Tap desired mark.
Event
mark
New
To Next Page
Loading...
Need help?
General