2. CHART PLOTTER
2-16
2.10.4 Speed alarm
The speed alarm tells you when the speed of your ship is over or under the limit set.
Set the value at [Speed Alarm Value].
Note: Requires connection to appropriate sensor.
1. Tap [Speed Alarm] on the [Alarm] menu.
2. Tap [Over] or [Under].
3. Tap [Speed Alarm Value] to display the software keyboard.
4. Set the value for [Over] or [Under] then tap [9].
5. Tap the close button to finish.
Note: To disable this alarm, turn it off at step 2 of the above procedure.
2.10.5 Anchor watch alarm
The anchor watch alarm tells you that your ship has moved a distance greater than
the set value when the ship must not be moving.
1. Turn on [Anchor Watch Alarm] in the [Alarm] menu.
2. Tap [Anchor Watch Alarm Value] to display the software keyboard.
3. Set the value, then tap [9].
4. Tap the close button to finish.
Note: To disable this alarm, turn it off at step 1 of the above procedure.
Your ship's position where you
start the anchor watch alarm.
Alarm
setting
: Alarm area
To Next Page
Loading...
Need help?
General