EasyManuals Logo

Furuno NavNet TZtouch3 Series User Manual

Furuno NavNet TZtouch3 Series
393 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #351 background imageLoading...
Page #351 background image
16-1
16. MAINTENANCE, TROUBLE-
SHOOTING
This chapter has information about maintenance and troubleshooting that the user
can follow to care for the equipment.
16.1 Maintenance
Routine maintenance helps keep your equipment in good condition and prevents fu-
ture problems. Check the items shown in the table below on a regular basis to help
keep your equipment in good condition for years to come.
Check item Check point Remedy
Cables Cable connection, corrosion Connect loosened cables. Replace any damaged
cables.
Cabinet Dust on the cabinet Remove dust with a dry, clean cloth. Do not use
commercial cleaners to clean the equipment - they
can remove paint and markings.
LCD Dust on the LCD Wipe the LCD carefully to prevent scratching, us-
ing tissue paper and an LCD cleaner. To remove
dirt or salt deposits, use an LCD cleaner, wiping
slowly with tissue paper so as to dissolve the dirt or
salt. Change paper frequently so the salt or dirt will
not scratch the LCD. Do not use solvents such as
thinner, acetone or benzene for cleaning. Also, do
not use degreaser or anti-fog solution, as they can
strip the coating from the LCD.
Waterdrops on the LCD Waterdrops on the LCD can slow touch response.
Wipe the LCD with a dry, soft cloth to remove the
water.
Radar
antenna
Foreign material on the radar
antenna
Foreign material can reduce sensitivity. Clean the
antenna with a cloth wetted with freshwater. Do not
use commercial cleaners to clean the radiator -
they can remove paint and markings.
Transducer Transducer face Marine growth on the transducer face can reduce
sensitivity. Remove any growth with a wooden
stick or fine grade sandpaper.
WARNING
ELECTRICAL SHOCK HAZARD
Do not open the equipment.
Only qualified persons can
work inside the equipment.
NOTICE
Do not apply paint, anti-corrosive
sealant or contact spray to plastic
parts or equipment coating.
Those items contain products that can
damage plastic parts and equipment
coating.

Table of Contents

Other manuals for Furuno NavNet TZtouch3 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Furuno NavNet TZtouch3 Series and is the answer not in the manual?

Furuno NavNet TZtouch3 Series Specifications

General IconGeneral
BrandFuruno
ModelNavNet TZtouch3 Series
CategoryMonitor
LanguageEnglish

Related product manuals