DC12-24V
DC24V
SCX-20
SC-30/33
IF-NMEAFI
FAR-2xx7/2xx8 series
FAR-15x3/15x8 series
BBDS1, DFF series
FUSION-Link compatible devices
Autopilot
NAVpilot-300/
NAVpilot-711C
IP Camera
Control Unit MCU-005
Radar Sensor (Radome)
DRS4DL/DRS4DL+/DRS4D-NXT
Ethernet
Hub*
2
HUB-101
PoE Hub*
3
USB Hub
Control Unit
MCU-002/MCU-004 or
SD Card Unit SDU-001
CCD Camera
Touch Monitor*
5
(HDMI Output)
Event Switch
External Buzzer
Power Switch
NMEA0183 Output
Junction
Box
FI-5002
Ship’s main
12 to 24V DC
Multi-beam Sonar DFF-3DMulti-beam Sonar DFF-3D
Multi Function
Display*
1
TZT16F/19F
Multi Function
Display*
1
TZT16F/19F
HDMI Source Devices
: Standard supply
: Optional/local supply
Radar Sensor (Open)
DRS6A X-Class/DRS12A X-Class/DRS25A X-Class
DRS6A-NXT/DRS12A-NXT
/
DRS25A-NXT
Select an antenna type:
Radome or Open.
CCD Camera
USB Host/Devices*
4
Category of units
Antenna unit: Exposed to the weather.
Other units: Protected from the weather.
Transducer*
6
Fish Finder
Power Amplifier
DI-FFAMP
*
2
: A maximum of 6 units of NavNet TZtouch2/3 can be connected. NavNet TZtouch2 requires software
version 7 or later. For configurations with TZT2BB included, a maximum of 4 NavNet TZtouch2/3
units can be connected. NavNet TZtouch cannot be connected.
*
3
: Use a commercially available PoE hub. The NETGEAR GS108PE has tested as compatible.
The basic functions of the hub were verified, however the compatibility of all functions were not
checked. FURUNO cannot guarantee proper operation.
*
5
: The HDMI output resolution is fixed to 1920x1080. To use a touch monitor for operation, its output
resolution must be 1920x1080 (Aspect ratio 16:9) with HPD (Hot Plug Detection) function.
*
4
: When using a USB OTG as a USB host device, this equipment operates as a touch operation
output device.
*
6
: Some transducers require connection of a 12-to-10 pin conversion cable.
*
1
: This unit has a built-in fish finder as standard.
FA-40/70
or
Transducer
To Next Page
Loading...
Need help?
General