15. OTHER FUNCTIONS
15-10
[NETWORK SENSOR SETUP] section
The [NETWORK SENSOR SETUP] section allows you to set up compatible FURUNO
NMEA2000 sensors. Calibrations and offsets applied in this menu are also applied to
the sensor itself.
[CALIBRATION] section
[DATA DAMPING] section
[FUSION] section
[BROWSER INSTALLATION] section
Others menu items
Menu item Description Options (setting range)
[Heading] Offset heading data. -180.0 to +180.0°
[Speed Through
Water]
Calibrate speed data. Enter amount in percentage. -50 to +50%
[Wind Speed] Offset wind speed data. Enter amount in percentage. -50 to +50%
[Wind Angle] Offset wind angle data. -180.0 to +180.0°
[Sea Surface
Temperature]
Offset sea surface temperature data. -50 to +50°F
Menu item Description Options (setting range)
[COG & SOG] Set data damping time. The lower the set-
ting the faster the response to change.
0 to 59 seconds
[Heading]
[Speed Through Water]
[Wind Speed&Angle]
[Rate of Turn]
Menu item Description Options (setting range)
[Connect to Fu-
sion]
Connect to your Fusion equipment.
[Fusion Auto
Volume]
Set to [ON] to allow this unit to control the Fusion vol-
ume automatically.
[OFF], [ON]
[Minimum
Speed]
Set the minimum speed threshold. Exceeding this
speed activates volume auto control.
0 to 99 kn
[Maximum
Speed]
Set the maximum speed threshold. 0 to 99 kn
[Volume In-
crease]
Set the amount of extra volume to output. 10 to 50%
Menu item Description
[FAX-30 Browser] Show the Facsimile Receiver FAX-30 display.
[FA-30 Browser] Show the AIS Receiver FA-30 display.
[FA-50 Browser] Show the AIS Receiver FA-50 display.
Menu item Description Option (setting range)
[Chart Master Device] Set to [ON] to set this equipment as the chart
master ([OFF]: sub).
[OFF], [ON]
[System ID] The system ID for this device within the network.
[IP Address] IP address for this unit within the network.
[Synchronization Log] Synchronization log for this unit within the network.
To Next Page
Loading...
Need help?
General