GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 3 - System Setup 3 - 129
3-11-10-6 Set-up of DICOM Server in Vivid 7’s Configuration Screens - Software v2.x (cont’d)
4.) Change the Name to a name you pick for the DICOM server (e.g. ProSolv server). It doesn’t really
matter what this name is.
5.) Change the AE Title to the name you got from the network administrator. This name must match
exactly and is case sensitive.
6.) Change the port number to the number you got from the administrator.
7.) Don’t touch the other settings, meaning they should be as follows:
8.) Press F2
(CONFIG) on the alphanumeric keyboard to exit config. REBOOT the system.
Figure 3-137 Set DICOM Server’s Name
Figure 3-138 DICOM Server’s Settings
Parameter Setting Comments
Allow raw data Unchecked
Max Framerate 25
You can go up to 30, but don’t select full, as it may
increase Image Store time
Only Black and White Unchecked
Compression JPEG
Allow multiframe Checked
Reopen per image Unchecked
Table 3-21 Default DICOM Setup in Vivid 7’s Configuration Screen
Change this
Name
AE Title
Allow Raw Data
enabler
Allow Multi frame
enabler
Max Framer ate drop-
down menu setting
Compression
drop-down menu
Port No.
Quality % setting
To Next Page
Loading...
