GE Vivid 7 - Page 340

GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
4 - 76 Section 4-3 - Functional Checks
4-3-20-5 VCR Record Check
4-3-20-6 Check Rewind, Fast Forward and Replay Video
Prerequisite:
A Video Tape in the VCR with at least one recorded examination.
Table 4-38 VCR Checks
Step Task Expected Result(s)
1.
When scanning, press REC/PAUSE on the Operator
Panel.
The VCR starts recording.
A red dot is displayed in the screen’s VCR status area
on the Title bar. It indicates that recording has begun
2.
Press REC/PAUSE
on the Operator Panel to stop
recording.
The Recording stops.
The video status icon on the screen is changed to
(Pause)
3.
Note the counter meter setting on the VCR .
Table 4-39 VCR Checks
Step Task Expected Result(s)
1.
Press VIDEO
on the Operator Panel. The Mode Dependant Keys changes to VCR controls
2.
Press REWIND
(Mode Dependant button)
The VCR starts to rewind the video tape.(observe the
counter)
3.
Press STOP
(Mode Dependant button) The VCR Stops
4.
Press FAST FORWARD (Mode Dependant button) The VCR starts the Fast Forward (observe the counter)
5.
Use the controls above to navigate to the start of the
recorded examination.
Then press PLAY
(Mode Dependant button) to replay
the recording
The replay of the examination starts.
6.
While in playback mode, use the Trackball to adjust
the video playback speed and scroll through the record.
The replay of the examination responds according to
your commands
7.
Press PAUSE
to stop the tape at the desired frame. The tape stops at the desired video frame.
8.
When playing back an examination
part of it can be stored on the computer’s memory as a
cineloop.The cine loop enables the user to perform
further operations on the stored section (see for further
information on cine loop operation).
9.
Press FREEZE
while playing back a recorded session.
To store a recorded sequence as a cine loop The
last few seconds are stored as a cine loop.