GE HEALTHCARE
DIRECTION FC091194, REVISION 11 VIVID 7 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8 - 71
8-9-14-2 Vivid 7 System Software Loading - Software Version v2.x
1.) Insert the applicable Vivid 7 System Software CD into the CD drive, see Table 8-20 "Record
Software and hardware versions" on page 8-69.
2.) Power down the System, see 4-2-3 "Power Shut Down" on page 4-7.
3.) Wait until the LCD’s on the Operator Panel are switched off and the ON/Standby switch has turned
amber.
4.) Power ON the System, see 4-2-2 "Power ON/ Boot UP" on page 4-3. The scanner will now boot
from the CD you inserted.
Figure 8-66 BIOS loading example
To Next Page
Loading...
