Cinterion
®
EHS6 AT Command Set
12.8 AT+CMGW
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 334 of 513
Notes
• Note that some providers do not recognize an @ symbol used in a short message. A widely used alternative
is typing "*" as defined in 3GPP TS 23.040 [36].
• In general but especially at baudrates below 19200 it is recommended to only use the command line termi-
nation character (ATS3) before starting text or PDU input. Use of line termination character followed by an
additional response formatting character (ATS4) may cause the problem that the latter will become part of the
input data.
• SMS-COMMANDs and SMS-STATUS-REPORTs cannot be stored in text mode.
• All characters entered behind the ">" prompt will be recognized as GSM characters. For example, "Back-
space" (ASCII character 8) does not delete a character, but will be inserted into the short message as an addi-
tional physical character. As a result, the character you wanted to delete still appears in the text, plus the GSM
code equivalent of the Backspace key.
PIN Last Reference(s)
+ + - 3GPP TS 27.005 [44], 3GPP TS
23.038 [35]
To Next Page
Loading...
