Cinterion
®
EHS6 AT Command Set
19.6 AT^SRADC
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 461 of 513
EXAMPLE 3
Periodic measurement at high sample rate (250ms):
EXAMPLE 4
Handling of "^SRADC" URCs and AT command execution on the same interface:
AT^SRADC=1,250
Start periodic measurement on the ADC channel.
Samples are taken every 250ms. Every second a
URC "^SRADC" appears to report the measured volt-
age. The number of samples is 5.
^SRADC: 5,76,76,77,76,76
^SRADC: 5,76,76,75,76,76
^SRADC: 5,77,77,76,76,76
^SRADC: 5,76,76,75,76,76
AT^SRADC=0
OK
Stop the periodic measurement
AT^SRADC=1,250
Start periodic measurement mode on the ADC chan-
nel. Samples are taken every 250ms.
^SRADC: 5,76,76,77,76,76
^SRADC: 5,76,76,75,76,76
^SRADC: 5,77,77,76,76,76
^SRADC: 5,76,76,75,76,76
AT^SRADC?
Input of AT command and <CR> takes some sec-
onds.
^SRADC: 1,250
OK
^SRADC: 5,75,75,75,75,75
Some URCs were buffered during command input
and sent after completion.
^SRADC: 5,76,76,77,76,76
^SRADC: 5,76,76,75,76,76
^SRADC: 5,77,77,76,76,76
^SRADC: 5,76,76,75,76,76
^SRADC: 5,77,77,76,76,76
^SRADC: 5,76,76,77,76,77
^SRADC: 5,76,76,75,76,76
To Next Page
Loading...
Need help?
General
