Cinterion
®
EHS6 AT Command Set
2.12 AT^SCFG
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 65 of 513
“ 8“ 118
“16“ 119
“32“ 999
“64“ Reserved
“128“ Reserved
“255“ All additional emergency call numbers are supported.
Dormancy Mode
This parameter controls the Dormancy Mode.
Parameter is global for all interfaces, non-volatile and will not be reset by AT&F.
Changed setting will take effect only after restarting the module.
“0“
(D)
Disable Dormancy Mode, i.e., the ME behaves as requested by the used
USIM.
“1“ Enable Dormancy Mode.
eCall USIM
This parameter provides the information if an eCall-Only-USIM ("eUSIM") is used.
“0“ eCall-Only-USIM not detected.
“1“ eCall-Only-USIM detected .
The user defined settings of Dormancy Mode are overruled by an eCall-Only-USIM. If Dormancy Mode is acti-
vated by the user, the ME behaves identical to the functionality as requested by an eCall-Only-USIM, meaning
the ME will camp on the network in "eCall-Inactive-State" (see 3GPP TS 24.008) and will only register to a net-
work for eCall execution.
If Dormancy Mode is activated (or an eCall-Only-USIM is used) when the eCall Callback Timer (see parameter
<callbacktimeout>) expires (indicated by URC "+CIEV"="ecaller,5"), the module deregisters automatically
from the network and returns to camping on the PLMN in the "eCall-Inactive-State".
Speech Codec
Speech Codec Configuration for voice calls
This parameter can be used to configure the speech version indications in the bearer capabilities in case of voice
calls (see 3GPP TS 24.008). If you change this parameter the command returns "OK", a new setting takes effect
the next time the UE is restarted (after power-cycle). Parameter is global for all interfaces, non-volatile and will
not be reset by AT&F.
“0“
(D)
All supported speech codecs are enabled for voice calls.
“1“ The speech codecs GSM HR, GSM HR AMR and GSM AMR are disabled for
voice calls.
Mode of operation for signal lines
This parameter can be used to configure shared signal lines of the EHS6 module. Depending on the connected
devices the setting determines the specific function assigned to the related signal line(s). Keep in mind that the
functions assigned to shared lines are mutually exclusive. When a line is reserved for one interface, then the
<g_mode> parameter is automatically set to 'rsv' for all other interfaces that use this line.
For example, to enable the SPI interface select AT^SCFG="GPIO/mode/SPI","std". This will automatically set
AT^SCFG="GPIO/mode/DSR0","rsv" for DSR0 used as SPI_CLK line for SPI and AT^SCFG= "GPIO/mode/
ASC1","rsv" for ASC1 (ASC1 lines used as SPI lines). At the same time this will lock the GPIO functionality of
GPIO3, GPIO16, GPIO17, GPIO19.
To enable the DAI interface select AT^SCFG="GPIO/mode/DAI","std". This will lock the GPIO functionality of
<dormancy>
(str)(NV)
<eCallUSIM>
(str)
<scc>
(str)(NV)
<g_mode>
(str)(+CSCS)(NV)
To Next Page
Loading...
Need help?
General
