6 System Functions
System
Date/Time
Enables you to configure the scheduler to run a task starting from this date and time. The date and time
rely on the instrument’s local time to execute a scheduled task. The date is based on the format
“YYYY/MM/DD” and the time is based on a 24 hour clock.
Key Path
System, Alignments, RF Preselector, Schedule Setup
Mode All
Remote Command
:CALibration:RFPSelector:SCHeduler:TIME:STARt ”date”,”time”
:CALibration:RFPSelector:SCHeduler:TIME:STARt?
This query returns data using the following format ”YYYY/MM/DD; HH:MM:SS”
Example :CAL:RFPS:SCH:TIME:STAR ”2009/8/20”, ”12:00:00”
Notes “date” is representation of the date the task will run in the form of “YYYY/MM/DD” where:
−YYYY is the four digit representation of year. (for example, 2009)
−MM is the two digit representation of month. (for example, 01 to 12)
−DD is the two digit representation of the day. (for example, 01 to 28, 29, 30 or 31 depending
on the month and year)
“time” is a representation of the time of day the task will run in the form of “HH:MM:SS” where:
−HH is the two digit representation of the hour in 24 hour format
−MM is the two digit representation of minute
−SS is the two digit representation of seconds
For model N9038A only.
Preset This is unaffected by Preset but is set to Current date and 00:00:00 on a “Restore System Defaults-
>Align”.
State Saved No
Initial S/W Revision A.08.00
Date
Enables you to configure the date of the scheduled task. The SCPI command to configure the date and
time parameters of the scheduler is the same; however, they each have their own front-panel control.
Key Path
System, Alignments, RF Preselector, Schedule Setup, Date/Time
Notes See "Date/Time " on page 329.
For model N9038A only.
Preset This is unaffected by Preset but is set to Current date and 00:00:00 on a “Restore System Defaults-
>Align”.
State Saved No
Initial S/W Revision A.08.00
EMI Receiver Mode Reference 329
To Next Page
Loading...
Need help?
General
