Lexmark 940e - X Color Laser Service Manual

Diagnostic information 2-163
7510
925.01 Sensor (M ATC) error
925.02 Sensor (C ATC) error
3
Perform a very large print test.
Does the error continue?
Replace the upper
printer engine card
assembly.
Go to “Upper
printer engine
card assembly
removal” on
page 4-77.
Problem solved.
Step Check Yes No
1 Reset the M ATC failure lock out condition.
1. Enter diagnostic mode
2. Touch ATC sensor failure clear
3. Touch M channel (925.01)
Perform a very large print test.
Does the error remain?
Go to step 2. Problem solved.
2
Check the sensor (M ATC) for proper connection.
Is the above component properly connected?
Replace the M
Developer unit
assembly.
Go to “Developer
unit assembly
removal” on
page 4-52.
Replace the
connection.
3
Perform a very large print test.
Does the error continue?
Replace the upper
printer engine card
assembly.
Go to “Upper
printer engine
card assembly
removal” on
page 4-77.
Problem solved.
Step Check Yes No
1 Reset the C ATC failure lock out condition.
1. Enter diagnostic mode
2. Touch ATC sensor failure clear
3. Touch C channel (925.02)
Perform a very large print test.
Does the error continue?
Go to step 2. Problem solved.
Step Check Yes No

Lexmark 940e - X Color Laser Specifications

General

Brand	Lexmark
Model	940e - X Color Laser
Category	All in One Printer
Language	English