3-48 Service Manual
7510
When the first stage of the process completes, the printer displays the following graphic and then begins the
second stage of the process:
The entire process is complete when the progress bar appears completely shaded and the percentage indicator
shows 100%. The panel returns to the screen that shows the values for the Wipe Disk setting.
Font Sharpening
This setting allows you to set a text point size below which the high-frequency screens are used when printing
font data. For example, at the default 24, all text in font sizes 24 and less will use the high frequency screens.
The values for this setting range from 0 to 150.
To change this setting:
1. Touch Font Sharpening from the Configuration Menu.
2. Touch to increase the value or to decrease the value.
3. Touch Back to cancel and return to the Configuration Menu.
4. Touch Submit to save the change.
This setting affects the PostScript, PCL, PDF, and XL emulators.
This function is not supported when the device generates output at 600 dpi resolution.
Wiping Disk
2/2 0%
DO NOT
POWER OFF
To Next Page
Loading...
Need help?
General
