Nitsuko 1232 - Page 232

¾ 5-35 ¾
Program 74
This program assigns Caller-ID timers. (Optional Item for Caller-ID feature.)
- Item-1 in this program assigns waiting time for Caller-ID signal from PTT.
- Item-2 in this program assigns detecting time for incoming signal.
- Item-3 in this program assigns duration time for Caller-ID signal.
- Item-4 in this program assigns detection time for Caller-ID signal carrier.
Display Indication Input Data Initial
CALLER-ID# TIMERS
#####74-N###-TTT
N. 1: Caller-ID signal waiting timer
2: Incoming signal detection timer
3: Caller-ID signal duration timer
4: Caller-ID signal carrier detection
TTT. 000: Not time out
001 - 015: 1 s - 15 s <N = 1>
000 - 015: 0 - 1.5 s <N = 2>
000 - 015: 0 - 750 ms <N = 3>
000 - 008: 500 - 900 ms <N = 4>
009 - 014: 1 s - 2 s
015: 3 s
(N = 1)
TTT = 007
(N = 2)
TTT = 001
(N = 3)
TTT = 000
(N = 4)
TTT = 015
Program 75
This program assigns auto dial in DISA feature, Common Abbreviated Area, Automatic Line Seizing
by SLT, Key Telephone Off-Hook Mode Selection and Long Conversation Cutoff on an extension
basis.
Display Indication Input Data Initial
STN# ASSIGNMENT5
#####75-ST-ABCDE
ST. Extension number
A. Auto dial assignment (TX-Z 1232/2464 only)
0: No function
1: Pager only
2: Mobile-phone only
3: Both Pager and Mobile-phone
B. Common Abb. Dial Area Arrangement
0: Disable 1: Enable
C. SLT Automatic Trunk Access
0: Disable 1: Enable
D. KTS Off-Hook Mode Selection
(TX-Z 824/1232/2464 only)
0: No tone
1: Seize Intercom
2: Seize idle trunk line
E. Long Conversation Cutoff
0: Disable 1: Enable
(308)
A: 0
B: 0
C: 0
D: 0
E: 0
(824/1232
/2464)
A: 0
B: 0
C: 0
D: 1
E: 0
(All
Extensions)