Panasonic FP Series User Manual

Special instructions
1002
Part III FP Instructions
LD
ST
When programming with structured text, enter the following:
IF start THEN
(* Sets the self-diagnostic error 100 *)
(* The ERROR/ALARM LED of the PLC is on,
and operation stops. *)
F148_ERR(100);
END_IF;

Panasonic FP Series Specifications

General

Mounting	DIN rail
Type	PLC
Communication Interface	RS-232, RS-485, Ethernet (depending on model)
Input Voltage	100-240V AC or 24V DC (depending on model)
Output Type	Relay, Transistor
I/O Points	Varies by model
Operating Temperature	0°C to 55°C
Dimensions	Varies by model
Weight	Varies by model