Panasonic FP Series

High-speed counter instructions
1160
Part IV Tool Instructions
HscInfo_IsCounting
Disabled
Checks if counting is disabled
See also:
 Tool instructions: overview of high-speed counter instructions
 HscControl_CountingDisable (see page 1139)
 HscControl_Cou
ntingEnable (see page 1141)
 FP instructions
Enabling/disabling counting operations (see page 891)
PLC types see page 1327
Variable Data type Function
iChannel INT High-speed counter channel:
FP
: 0, 2
FP-X R: 0, 1
FP-X 16K C14T: 0, 1, 2
FP-X 32K C30T, C60T: 0, 1, 2, 3
FP0R: 0, 1, 2, 3
FP0: 0, 1
FP-e: 0, 1
Output variable BOOL TRUE if counting on the channel specified by iChannel is
disabled
Description
This instruction returns TRUE if counting on the channel specified by iChannel has been disabled.
Data types
Example
In this example the function has been programmed in ladder diagram (LD) and structured text (ST).
The same POU header is used for all programming languages.
POU header
All input and output variables used for programming this function have been declared in the POU
header.
Body
LD
ST
When programming with structured text, enter the following:
if (bCountingDisabled_Check) then
bCountingDisabled := HscInfo_IsCountingDisabled(iChannel := iChannel);
end_if;