Panasonic FP Series

Pulse output instructions
1221
Part IV Tool Instructions
PulseInfo_GetControl
Code
Returns control code of pulse output channel
See also:
Pulse output tool instructions in the online help
PLC types see page 1329
Variable Data type Function
iChannel INT Pulse output channel:
FP
: 0, 2
FP-X R: 0, 1
FP-X 16K C14T: 0, 1, 2
FP-X 32K C30T, C60T: 0, 1, 2, 3
FP0R: 0, 1, 2, 3
FP0: 0, 1
FP-e: 0, 1
Output variable WORD Stores the control code
Description
This instruction returns the control code (see page 1021) of the pulse output channel specified by
iChannel.
Data types
Example
In this example the function has been programmed in ladder diagram (LD) and structured text (ST).
The same POU header is used for all programming languages.
POU header
All input and output variables used for programming this function have been declared in the POU
header.
Body
LD
ST
When programming with structured text, enter the following:
if (bReadControlCode) then
wChannelControlCode := PulseInfo_GetControlCode(iChannel := iChannel);
end_if;