Panasonic FP Series

Pulse output instructions
1226
Part IV Tool Instructions
PulseInfo_IsCounting
Disabled
Checks if pulse counting is disabled
See also:
 Pulse output tool instructions in the online help
 PulseControl_CountingDisable (see page 1198)
 PulseCo
ntrol_CountingEnable (see page 1200)
 FP instructions
Enabling/disabling counting operations (see page 1021)
PLC types see page 1329
Variable Data type Function
iChannel INT Pulse output channel:
FP
: 0, 2
FP-X R: 0, 1
FP-X 16K C14T: 0, 1, 2
FP-X 32K C30T, C60T: 0, 1, 2, 3
FP0R: 0, 1, 2, 3
FP0: 0, 1
FP-e: 0, 1
Description
This instruction returns TRUE if counting on the channel specified by iChannel has been disabled.
Data types
Example
In this example the function has been programmed in ladder diagram (LD) and structured text (ST).
The same POU header is used for all programming languages.
POU header
All input and output variables used for programming this function have been declared in the POU
header.
Body
LD
ST
When programming with structured text, enter the following:
if (bChannelCounting_Check) then
bCountingDisabled := PulseInfo_IsCountingDisabled(iChannel :=
iChannel);
end_if;