Panasonic FP Series

Pulse output instructions
1050
Part III FP Instructions
 The status of the high-speed counter control flag or pulse output control flag may
change while a scan is being carried out. For example, if the flag is used more
than once as an input condition, different statuses may exist within one scan. To
ensure proper execution of the program, the status of the special internal relay
should be copied to a variable at the beginning of the program.
REFERENCE
Please refer to the FPWIN Pro online help for detailed information on using system variables.
Output relays and system variables for FP0R
PLC types Availability of F171_PulseOutput_Trapezoidal (see page 1322)
Variable Data type Function
s_dutDataTable
FP-
, FP-X:
F171_PulseOutput_Trapezoidal_DUT
FP0R:
F171_PulseOutput_Trapezoidal_Type0_DUT
F171_PulseOutput_Trapezoidal_Type1_DUT
Starting address of area containing the
data table
n_iPulseOutputChannel decimal constant Pulse output channel:
FP-
: 0, 2
FP-X R: 0, 1
FP-X C14T: 0, 1, 2
FP-X C30T/C60T: 0, 1, 2, 3
FP0R: 0, 1, 2, 3
For Relay T/C Register Constant
s_dutDataTable - - - - - - DT - - -
n_iPulseOutputChannel - - - - - - - - - dec. or hex.
No. IEC address Set If
R9007 %MX0.900.7 permanently
R9008 %MX0.900.8 for an instant
 channel number or values of the data table are outside the
permissible range
 initial speed > target speed
 FP0R/FP-X:pulse output has not been set in the system
registers
Data types
Operands
Error flags