Appendix Programming Information
1314
Error
code
Name Description
!42 No support error A non-supported command was received.
!43 Multiple frames
procedure error
A different command was received when processing multiple frames.
!50 Link setting error A non-existing route number was specified. Verify the route number by
designating the transmission station.
!51 Transmission time-out
error
Transmission to another device is not possible because the transmission buffer
is full.
!52 Transmit disable error Transmission processing to another device is not possible (link unit runaway,
etc.).
!53 Busy error Processing of command received is not possible because of multiple frame
processing or because command being processed is congested.
!60 Parameter error Content of specified parameter does not exist or cannot be used.
!61 Data error There was a mistake in the contact, data area, data number designation, size
designation, range, or format designation.
!62 Registration over error Operation was done when number of registrations was exceeded or when there
was no registration.
!63 PC mode error PC command that cannot be processed was executed during RUN mode.
!64 External memory error An abnormality occurred when loading RAM to ROM/IC memory card. There
may be a problem with the ROM or IC memory card. When loading, the
specified contents exceeded the capacity. Write error occurs.
ROM or IC memory card is not installed.
ROM or IC memory card does not conform to specifications
!65 Protect error A program or system register write operation was executed when the protect
mode (password setting or DIP switch, etc.) or ROM operation mode was being
used.
!66 Address error There was an error in the code format of the address data. Also, when
exceeded or insufficient address data, there was a mistake in the range
designation.
!67 No program error and
no data error
Cannot be read because there is no program in the program area or the
memory contains an error. Or, reading of non-registered data was attempted.
!68 Rewrite during RUN
error
When inputting with programming tool software, editing of an instruction (ED,
SUB, RET, INT, IRET, SSTP, and STPE) that cannot perform a rewrite during
RUN is being attempted. Nothing is written to the CPU.
!70 SIM over error Program area was exceeded during a program write process.
!71 Exclusive access
control error
A command that cannot be processed was executed at the same time as a
command being processed.
To Next Page
Loading...
