Table of Contents
18
F10_BKMV_NUMBER_OFFSET Block move by number to an offset from source
824
F11_COPY Block copy
825
F12_EPRD EEPROM read from memory
827
F12_ICRD IC card extended memory read
829
F13_ICWT IC card extended memory write
831
F14_PGRD Program Read from IC card
833
P13_EPWT EEPROM write to memory
834
F15_XCH 16-bit data exchange
836
F16_DXCH 32-bit data exchange
837
F17_SWAP Higher/lower byte in 16-bit data exchange
839
F18_BXCH 16-bit blocked data exchange
841
F143_IORF Partial I/O update
843
F147_PR Parallel printout
845
F150_READ Data read from intelligent units
848
F151_WRT Write into memory of intelligent units
851
F190_MV3 Three 16-bit data move
854
F191_DMV3 Three 32-bit data move
856
F309_FMV Floating Point Data Move
858
24.1 Data transfer to and from special data registers....................................................................859
24.2 Transferring data to and from file register banks 1 or 2.........................................................860
ReadDataFromFileRegisterBank Read Data from File Register Bank 1 or 2
861
WriteDataToFileRegisterBank Write Data to File Register Bank 1 or 2
863
25. Date and time instructions.....................................................................865
F138_TIMEBCD_TO_SECBCD h:min:s -> s conversion
866
F139_SECBCD_TO_TIMEBCD s -> h:min:s conversion
867
F157_ADD_DTBCD_TIMEBCD Time addition
868
F158_SUB_DTBCD_TIMEBCD Time subtraction
870
F230_DTBCD_TO_SEC Time Data Conversion into Seconds
872
F231_SEC_TO_DTBCD Conversion of Seconds into Time Data
873
GET_RTC_DTBCD Read the Real-Time Clock
874
SET_RTC_DTBCD Set the Real-Time Clock
875
26. Selection Instructions.............................................................................877
F285_LIMT 16-bit data upper and lower limit control
878
F286_DLIMT 32-bit data upper and lower limit control
880
To Next Page
Loading...
Need help?
General
