Panasonic FP Series

Conversion instructions
670
Part III FP Instructions
For Relay T/C Register Constant
s, n WX WY WR WL SV EV DT LD FL dec. or hex.
d - WY WR WL SV EV DT LD FL -
No. IEC address Set If
R9007 %MX0.900.7 permanently
R9008 %MX0.900.8 for an instant
 the bit position specified at input n is not
between 0 and 15
 the conversion operation results in an
overflow of the address area at output d.
In this example bit_combination and position are declared as input variables. However, you can
write constants directly at the input contact of the function instead.
Operands
Error flags
Example
In this example, the same POU header is used for all programming languages. For an example
using IL (instruction list), please refer to the online help.
POU header
All input and output variables used for programming this function have been declared in the POU
header.
Body
When the variable start is set to TRUE, the function is carried out.
LD
ST
When programming with structured text, enter the following:
IF start THEN
F240_COLM( s:= bit_combination,
n:= position,
d=> data_field );
END_IF;