Quantum DXi6900

Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Integrated Storage Controller
Quantum DXi6900 G1 User’s Guide 137
2 Navigate to the Status > Hardware > Details > Storage Arrays
page.
3 Under Storage Arrays, click a0, and then note the status of the
PERC H710 below (see
Figure 78).
Figure 78 Checking Integrated
Storage Controller Status
Removing a Failed Integrated Storage Controller
To remove the integrated storage controller from the DXi6900 G1 Node:
1 Shut down the system (see Turning On and Shutting Down the
System on page 23).
2 Remove the Node cover (see Opening and Closing the Node on
page 78).
3 Remove the expansion card riser 1 (see Replacing an Expansion Card
in Riser 1).
4 Push down the two release levers at the edge of the integrated
storage controller card to disengage the card from the connector
(see
Figure 79).
5 Angle the card so that the other end of the card disengages from
the storage controller card holder on the system board.