Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Integrated Storage Controller
Quantum DXi6900 G1 User’s Guide 141
2 Connect to the system node via the iDRAC port and launch the
Virtual Console Viewer (see
Connecting to the System Node Using
the iDRAC Port on page 34).
3 Boot the system.
4 During the boot process, press <Ctrl+R> when prompted to enter
the PERC H710 RAID controller BIOS.
5 In the RAID BIOS, navigate to the VD Mgmt screen and select PERC
H710 Mini in the list (see
Figure 81).
Note: Some of the following illustrations show a PERC H700
controller instead of a PERC H710. The procedure is the
same for both.
Figure 81 PERC RAID BIOS -
Virtual Disk Management
6 Press F2 to display the operations menu, and then select Security
Key Management > Create Key (see
Figure 82).
To Next Page
Loading...
