Chapter 3: FRU Removal and Replacement Procedures
Replacing the Node Network Daughter Card
Quantum DXi6900 G1 User’s Guide 147
Figure 88 Removing and
Installing the Integrated
Storage Controller Battery
Installing a Replacement Integrated Storage Controller
Battery
To install the replacement integrated storage controller battery in the
DXi6900 G1 Node:
1 Plug the replacement battery cable into the integrated storage
controller and insert the battery into the controller (see
Figure 88).
2 Replace the integrated storage controller (see Replacing the
Integrated Storage Controller).
3 Close the Node cover (see Opening and Closing the Node).
4 Run Factory Detect Hardware from the Service Menu to detect the
new hardware (see
Factory Detect Hardware on page 44).
5 In the remote management console, delete any administrative alerts
and close any service tickets.
Replacing the Node Network Daughter Card
This section describes how to remove and replace the network daughter
card in the DXi6900 G1 Node and contains the following sections:
• Obtaining a Replacement Network Daughter Card
Storage controller
battery
To Next Page
Loading...
