Quantum DXi6900

Chapter 1: Basic Operations
Accessing Remote Management
Quantum DXi6900 G1 User’s Guide 25
Turning off the DXi6900
G1
To turn off the system:
Caution: Before shutting down the DXi6900 G1, make sure that all
backup and replication jobs are finished, and that space
reclamation activity is complete.
1 Shut down the system from the remote management console using
the Shutdown option on the Utilities > Reboot & Shutdown page
(see
Accessing Remote Management on page 25).
Note: Shutting down the system can take up to 15 minutes. Only
the Node will completely shut down.
2 After the Node shuts down, turn off both power switches on the
back of each Array module (RBOD) (see
Figure 15). Wait until the
seven segment display on the rear of the module turns off.
3 Turn off both power switches on the back of each Expansion
module (EBOD) (see
Figure 14).
Accessing Remote Management
The Quantum DXi6900 G1 provides a powerful Web-based user
interface that allows you to configure and manage the system from a
remote workstation on the same network as the DXi6900 G1.
Note: For complete information about using all features of the
remote management console, refer to the Quantum DXi6900
User’s Guide (6-68159).
Access the remote management console using a Web browser on a
workstation that is on the same network as the DXi6900 G1.
See the following sections for more information about accessing
DXi6900 G1 remote management:
• Supported Browsers
• Logging On to the DXi6900 G1